EK-Loop OmniLink Pump SATA PWM D-RGB Signal Splitter cable allows users to connect D-RGB LED devices, SATA powered pumps and 4-Pin PWM fans to the OmniLink cable harness using their standard connectors. The OmniLink cable allows for an easy transmission and distribution of +12V and +5V Power; PWM, TACHO, and D-RGB signals. The cable features a stylish black ribbon cable for easy build integration and cable management.

Content:

- EK-Loop OmniLink Pump SATA PWM D-RGB Signal Splitter cable

Technical Specifications:

- Molex Micro-fit 3.0 8-pin Male connector to:

• 1x Molex Micro-fit 3.0 8-pin Female Connector
• 1x SATA Power Female Connector (Ground, +12V)
• 1x 4-Pin PWM 2 Fan Male Connector (Ground, +12V, TACHO, PWM)
• 1x 3-Pin D-RGB LED Female Connector (+5V, Data, Blocked, Ground)

- Cable length: 250±10mm

- Color: Black

- Power Wire gauge: AWG20

- Signal Wire gauge: AWG22

- Molex Micro-fit Connector current rating: 8.5A

- Power Cable current rating: 8A

- Signal Cable current rating: 6A

EK-Loop OmniLink Pump SATA PWM D-RGB Signal Splitter cable is compatible with all EK OmniLink products, PWM fan/pump speed control technology, and all popular D-RGB sync technologies from major motherboard manufacturers (if the header is supported). 

Only the PWM 2 signal is accessible with this OmniLink splitter cable, which is intended to control the pump speed. For the PWM2 signal to work, the the EK-Loop OmniLink 6-Pin Power (dual PWM) cable must also be used. It’s primarily used for adding a distro plate/combo into omnilink and consolidating all of the connectors into the harness.

For PWM2 signal to work, EK-Loop OmniLink 6-Pin Power (dual PWM) cable must be also used.

Designed in Slovenia, made in China

PLEASE NOTE:

• If EK-Loop FPT fans are placed at the start of the OmniLink series, it limits the current to 4.5A due to the thinner wire gauge of the cable.